Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Vantage by Epicor. Any opinions?

Status
Not open for further replies.
nozzlemaker

nozzlemaker

Mechanical
Joined
Mar 28, 2002
Messages
10
Location
GB
We are a small machine design affair trying to control the mess of components and BOM's we've created with Epicor.
Has anybody had any bad experiences moving into this software and if so any advice on how to make the transition less painful?
 
Status
Not open for further replies.

Similar threads

LeRepeteur
  • Locked
  • Question Question
Autodesk Fusion 360 - How to use Remote Load's in simulation to be defined by an area
Replies
0
Views
449
LeRepeteur
LeRepeteur
KA786
  • Locked
  • Question Question
I need help in sympy programming in Python any expert advise most welcome !!!!
Replies
2
Views
392
IRstuff
IRstuff
enghelp2806
  • Locked
  • Question Question
Anyone recognize this FEA solver language?
Replies
8
Views
569
FEMAP_MAN
FEMAP_MAN
caridea
  • Locked
  • Question Question
Anyone else here using SAFI?
Replies
4
Views
1K
caridea
caridea
Sparweb
  • Locked
  • Question Question
Onshape bought by PTC
Replies
5
Views
385
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top