Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Utilization Ratio / Safety Factor / Postprocessing

Status
Not open for further replies.
TomekZeWschodu

TomekZeWschodu

Marine/Ocean
Joined
Jul 28, 2013
Messages
14
Location
PL
Hi All,

I have done an Advanced Simulation (SOL101) in NX9 and would like to display (do the result postprocessing) a utilization factor for each element with respect to it's own Yield Strength.
I have more than one material used in the analysis so simple reduction of the Stress is not a solution.

Any ideas ?

Naval Architect/ Structural Engineer
 
Status
Not open for further replies.

Similar threads

nxexplorer
  • Locked
  • Question Question
NX postprocessing for attributes only
Replies
0
Views
311
nxexplorer
nxexplorer
nxexplorer
  • Locked
  • Question Question
Make Warning when postprocessing for gauge check.
Replies
4
Views
300
nxexplorer
nxexplorer
nxexplorer
  • Locked
  • Question Question
NX Postprocessor - POSTBUILDER put the txt file contents into the output of postprocessing result.
Replies
2
Views
243
nxexplorer
nxexplorer
tejras
  • Locked
  • Question Question
Strength Safety Factor and Failure Analysis
Replies
4
Views
355
tejras
tejras
Lorente9
  • Locked
  • Question Question
CPU utilization during Motion Simulations
Replies
1
Views
168
cowski
cowski

Part and Inventory Search

Sponsor

Back
Top