Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

using mastercam to program a mazak lathe

Status
Not open for further replies.
pbboyd

pbboyd

Industrial
Joined
May 26, 2004
Messages
5
Location
CA
I have a mazak quickturn 28n lathe with a mazatrol controller.
does any know of a post processor for mastercam that will work??
 
Sort by date Sort by votes
Contact your MasterCam reseller or check on the CD that was included with your software. One of those two places should solve your problem.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

paulcook
  • Locked
  • Question Question
Fusion 360 CAM VS MasterCAM
Replies
6
Views
3K
RobWard
RobWard
S
  • Locked
  • Question Question
Turning a 410 S.S 15mm round bar to 12.7mm
Replies
6
Views
3K
Saman2002
S
T
  • Locked
  • Question Question
Why use a buildbotics controller
Replies
0
Views
1K
thomas29
T
V
  • Question Question
Designing a Checking Jig for Sheet Metal Hole Positions After Bending
Replies
0
Views
7K
vutuankhanh
V
dogbural
  • Locked
  • Question Question
machining a long tube (380mm)
Replies
8
Views
4K
Gr8blu
Gr8blu

Part and Inventory Search

Sponsor

Back
Top