Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

User Defined Nodes Numbering

Status
Not open for further replies.
meshparts

meshparts

Mechanical
Joined
Feb 17, 2005
Messages
490
Location
DE
Hi,

I have an automaticaly meshed model that I want to use as superelement. Now I wish that the master nodes of the superelement are consecutiveley numbered from 1 to the maximum master node number.

I tried to use node number offset for selected nodes but it don't work, since the command NOOFFSET,NODE applies for the whole nodes.

I would appreciate any help on this topic.

Alex
 
Status
Not open for further replies.

Similar threads

X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
shiraz883
  • Locked
  • Question Question
Weld post processing using Fsum/PRNLD command on coupled nodes (cpintf)
Replies
0
Views
385
shiraz883
shiraz883
HarryBaals
  • Locked
  • Question Question
Simple Fix for an experienced Ansys Static Structural user
Replies
3
Views
803
SPDL310
SPDL310
Vitkacy1989
  • Locked
  • Question Question
How to connect part meshed with and without mid-side nodes ?
Replies
2
Views
348
Vitkacy1989
Vitkacy1989
julia_page
  • Locked
  • Question Question
Apply load on nodes without *do loop
Replies
1
Views
253
ikerg
ikerg

Part and Inventory Search

Sponsor

Back
Top