Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Use configuration name as part number in titleblock
- Thread starter therik
- Start date
Use Custom Properties, under File/Properties.
For a helpful link try
See AUTOMATIC RELOAD FOR THE SHEET FORMAT in this forum, there I have explain a way to use Custom Properties.
Hope that helps,
Scott Baugh, CSWP
For a helpful link try
See AUTOMATIC RELOAD FOR THE SHEET FORMAT in this forum, there I have explain a way to use Custom Properties.
Hope that helps,
Scott Baugh, CSWP
More specifically,
Create a template part and a template drawing so you can set file/properties.
Create a file property that you want to see, such as "configuration"
Edit the format and insert a note where you want the label to appear. Open the properties folder button and select the property you have created.
I have created formats for each plotter size and each customer as needed. I also create a template for each job for the parts and drawings. These templates have the properties already set to appear on the drawings and in the BOMs. This is a huge time saver.
Create a template part and a template drawing so you can set file/properties.
Create a file property that you want to see, such as "configuration"
Edit the format and insert a note where you want the label to appear. Open the properties folder button and select the property you have created.
I have created formats for each plotter size and each customer as needed. I also create a template for each job for the parts and drawings. These templates have the properties already set to appear on the drawings and in the BOMs. This is a huge time saver.
- Status
Similar threads
- Locked
- Question
- Question