Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Unlisted material, 7075-T6 Aluminum, for fitting design

Status
Not open for further replies.
mecha23

mecha23

Mechanical
Joined
Jul 5, 2006
Messages
1
Location
CA
I had a question regarding the use of an unlisted material for a design of a fitting. I am looking to use aluminum 7075-T6, which is not in the ASME code. I understand that for a fitting, there is more freedom for which materials can be used. I was looking for some input on if this materail would be possible to use for this fitting. Any help would be appreciated.

Thanks.
 
Status
Not open for further replies.

Similar threads

B
  • Question Question
What materials for design of ultra-supercritical boiler tubes?
Replies
2
Views
511
btwlzyq
B
torsani
  • Locked
  • Question Question
Table UW-16.1 manufacture's fitting thickness
Replies
2
Views
2K
IdanPV
IdanPV
J
  • Locked
  • Question Question
Supplier for SA612 plate material for PQR
Replies
1
Views
991
fleischfresser
fleischfresser
D
  • Locked
  • Question Question
DESIGN CRITERIA FOR BEM TYPE HEAT EXCHANGER
Replies
0
Views
1K
Dinesh2600
D
nashki
  • Locked
  • Question Question
Mix System Unit in Design and Material System Unit
Replies
4
Views
3K
nashki
nashki

Part and Inventory Search

Sponsor

Back
Top