Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ultrasonic Testing for Inclusion Detection 1

Status
Not open for further replies.
JNorman

JNorman

Mechanical
Joined
Oct 3, 2001
Messages
2
Location
CA
Any recommendations regarding choosing the appropriate standard to follow when ultrasonic testing steel, with the intention of detecting inclusions? The material tested is wrought steel, particulary finished 4140 components.

The ASTM online summaries of various ASTM standards do not allow enough detail to answer this question without outright purchasing a sample of the standards. Or correct me if I am wrong.
 
Sort by date Sort by votes
ASTM ASME A/SA388 IS WHAT I WOULD RECCOMEND THIS SPEC IS REFRENCED IN API 6A
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
Muza33
  • Locked
  • Question Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
738
Muza33
Muza33
Christian Dimitrov
  • Locked
  • Question Question
Forged flanges in A182 F347
Replies
7
Views
1K
EdStainless
EdStainless
N AHMAD
  • Locked
  • Question Question
TESTING OF DUAL CERTIFICATION F316/F316L.
Replies
4
Views
545
N AHMAD
N AHMAD
damianyu
  • Locked
  • Question Question
Aggregate testing for ASR potential?
Replies
0
Views
234
damianyu
damianyu

Part and Inventory Search

Sponsor

Back
Top