Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ultrasonic Testing for Inclusion Detection 1

Status
Not open for further replies.
JNorman

JNorman

Mechanical
Oct 3, 2001
2
Any recommendations regarding choosing the appropriate standard to follow when ultrasonic testing steel, with the intention of detecting inclusions? The material tested is wrought steel, particulary finished 4140 components.

The ASTM online summaries of various ASTM standards do not allow enough detail to answer this question without outright purchasing a sample of the standards. Or correct me if I am wrong.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
ASTM ASME A/SA388 IS WHAT I WOULD RECCOMEND THIS SPEC IS REFRENCED IN API 6A
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
Muza33
  • Locked
  • Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
663
Muza33
Muza33
Christian Dimitrov
  • Locked
  • Question
Forged flanges in A182 F347 1
Replies
7
Views
929
EdStainless
EdStainless
N AHMAD
  • Locked
  • Question
TESTING OF DUAL CERTIFICATION F316/F316L. 1
Replies
4
Views
402
N AHMAD
N AHMAD
damianyu
  • Locked
  • Question
Aggregate testing for ASR potential?
Replies
0
Views
189
damianyu
damianyu

Part and Inventory Search

Sponsor

Back
Top Bottom