Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UG 45(b)(4)

Thread starter juancito
Start date Oct 1, 2002

Status: Not open for further replies.

Oct 1, 2002

juancito

Mechanical

Along which length shall the minimun thickness based on UG 45(B)(4)be maintained. I want to mean that if for example for some particular reason a nozzle has to be 40 inch long., has all this length to comply with the above mentioned requirement, or only aorund the reinforment influence neighborhood? Soon answers will be kindely appreciated.
Thanks in advance