UF_MODL_intersect_objects API missing in NX8 (NXOpen) ?

[biw01]

Hello Freinds,

I was trying to use the API UF_MODL_intersect_objects (which determines the intersection between the two input objects and
outputs information describing the intersection) but i do not seem to find this API in the NXOpen help file for NX8. Have the siemens team come with a new API which has replaced this old one.I have use this API till NX7.5

Any help in this regard will be deeply appreciated.

Thanks,
Amitabh

 

[cowski]

It shows up in the API reference, but the .net wrapper seems to be missing. I would guess this is not intentional, you should contact GTAC and bring this to their attention.

www.nxjournaling.com

 

[biw01]

Thanks Cowski.I will bring it to the notice of GTAC.
Can you please help me out how I can open a complaint regarding the same on the GTAC website.

Regards,
Amitabh

 

[cowski]

You'll need a webkey account with GTAC, you can create one here:

https://plmapps.industrysoftware.automation.siemens.com/webkey/

Once you have your webkey account setup, you can go to: Help -> Online technical support -> log an incident with technical support; and fill out a form describing your problem. Or, you can call GTAC support (there is a phone number on the website) if you prefer.

www.nxjournaling.com