Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Typ, Both Sides and Other Notes

Status
Not open for further replies.

ModulusCT

Mechanical
Joined
Nov 13, 2006
Messages
212
Location
US
I've attached a pdf of a drawing that shows what I'm talking about.

A hole is dimensioned to a feature that is mirrored on the other side of the part. Is it appropriate to say "BOTH SIDES" or "TYP" to indicate that the dimensions apply on the other side of the part where the feature and hole relationship are mirrored?

Using a CL would be inappropriate because the part is not completely symmetrical.

Any help is appreciate.
 
Funny fcsuper, I used to think like that but as I've gone on the more convinced I am of the inadequacy/danger of using typ.

I think the deciding point was another thread on here somewhere where someone (or maybe more than 1) had a different definition of what typ meant than from how I've usually seen it implied. Given it's not in the newer versions of the standard, there is no where its definition is properly defined. So I TYP avoid it;-).

Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
 
:) And defining terms is always important. I'm not restricting its use right now, but may eventually give it a particular definition in our system.

Another more common use I've seen is in general not callouts, but not necessary abbreviated for things like typical draft...though in the age of the model based definition, I don't see much point for this anymore.

Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top