TWINCAT PLC Help

[AVGTech]

I need some advice/help on how to get started with twin cat software/programming. I have a tube bender with this control and need to make some changes drastically to reduce cycle time, the OEM programmer is no longer availabe and no one else with the machine builder is familiar with this software. I am not sure how they interchange but this is coupled to adept software some how, I am totally clueless with this combination.

 

[controlsdude]

thats a beckoff product, find you a distributor in the area where you are at, they can provide some expertise on what you editor you need and any manual in pdf to send you.

http://www.beckhoff.com/

go to this website , then go to the the contact tab and look for your rep. I would think that any distributor would be glad to help.

 

[arj3090]

If you are completely new with TwinCAT, here is a good start:

http://www.youtube.com/watch?v=h54gtseymrI