Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tutorials

Thread starter cadmate
Start date Sep 3, 2007

Status: Not open for further replies.

Sep 3, 2007

cadmate

Mechanical

Does anyone know of any good publications (Inventor 2008 Pro) that demonstrate Inventor studio, dynamic simulation, sheetmetal & all aspects of the design accelerator. The books that are available through the internet seem to basic learning, some dont even touch on the above, suppose i'm after intermediate/advanced level.
Many thanks in advance...