Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tutorials not working

Status
Not open for further replies.
T1936

T1936

Computer
Joined
Feb 5, 2005
Messages
56
Location
US
Hi All,

Using SolidEdge 19 on an x64 system and am having difficulty getting the tutorials to work.

They load up fine, but the little forward arrow used to advance to the next step of a tutorial seems to be grayed out, and I have no way of moving through the steps.

Does anyone else have this problem with the tutorials in SE19? Is there another way to use the tutorials?

Thanks,

Tim
 
Sort by date Sort by votes
Hi,

AFAIK there is a PR out on this, it's related to the 64-Bit version of SE only

dy
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

RC-o2
  • Locked
  • Question Question
The rollback event cannot allow saving of the active document because we could not get valid pointer
Replies
0
Views
898
RC-o2
RC-o2
garmancm
  • Locked
  • Question Question
Edges of part not showing in draft
Replies
1
Views
362
kjoiner
kjoiner
plantprowler
  • Locked
  • Question Question
Imported a dwg into a dft but not getting automatic dimensions on any new geometry
Replies
1
Views
246
KENAT
KENAT
gharli
  • Locked
  • Question Question
Solid Edge Viewer Not Allowing Sections
Replies
1
Views
259
ct27gt
ct27gt
ShaLad89
  • Locked
  • Question Question
SE ST7 shaded views in draft not printing in colour
Replies
4
Views
271
ShaLad89
ShaLad89

Part and Inventory Search

Sponsor

Back
Top