Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Turn auto dimansions to required ones in nx11

Thread starter Sopara
Start date Nov 7, 2020

Status: Not open for further replies.

Nov 7, 2020

Sopara

Student

Hello,
I just finished my sketch and I realized all dimensions are automotic. When I try to turn them to required some of automotic dimensions resistence to change so I wonder is there any easy way to turn all automatic dimansion to required? Thanks.