Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tsai hill criterion

Thread starter Ledub33
Start date May 26, 2014

Status: Not open for further replies.

May 26, 2014

Ledub33

New member

Hello,

I'm working on a layered composite shell part on Abaqus.
I'm using Tsai-Hill criterion to see where the part would yield.
I would like to know if there were anyway to know the percentage of surface in which the criterion has reached a value beyond 1.

Regards.