Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Triad

Status
Not open for further replies.

boldfish

Mechanical
Joined
Jan 29, 2003
Messages
101
Location
US
Is there a way to turn off the display of the triad in parts and assemblies?
 
Tools\Options\System Options\Display/Selection "Display Reference Triad" - Uncheck it.

This is a global setting so once unchecked it will be unchecked for all new and old documents

Regards,

Scott Baugh, CSWP [pc2]

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top