Sep 2, 2009 #1 JackofallMech Mechanical Jun 7, 2007 20 CADworx rejects my Solidworks .sat file immediately. Can anyone recommend some steps to translating between these to two software.
CADworx rejects my Solidworks .sat file immediately. Can anyone recommend some steps to translating between these to two software.
Sep 2, 2009 1 #2 rollupswx Mechanical Dec 31, 2007 918 I'm not sure what version of ACIS CADworx reads, but I know Autodesk products only read up to version 7 sat. When saving the file in Swx click Options and set to earlier version (I would try version 7). Upvote 0 Downvote
I'm not sure what version of ACIS CADworx reads, but I know Autodesk products only read up to version 7 sat. When saving the file in Swx click Options and set to earlier version (I would try version 7).
