toolbox hardware - lost configs?

[adampunch]

At my company, we recently switched our toolbox from a local setup to a networked setup. I opened an assembly that i had made before the switch, and now all of the hardware has reverted to a default size, and their confogurations are gone from the properties dialog box. SW is getting the files from the networked drive, and if i drag in an identical part from the toolbox, it allows me to set the proper size. Can i get the configurations back to the existing hardware in my assembly?

ps- we're all using SP4.0 now

SW 2008 Office Professional SP 3.0
Intel Xeon 3.40GHz
3 GB RAM
Windows XP SP 2

 

[adampunch]

not exactly anwering my own question, but here's what i did- I found the old copy of the hardware part files on my C drive and copied them to the corresponding folders on the network. I only did the hardware i was having problems with, so not to screw up anything else. The assembly seems to work fine now.

It's strange because for most assemblies, i get a dialog asking if i want to add missing configurations to the toolbox hardware when opening up an older assembly. Just didn't happen on this particular assembly.

SW 2008 Office Professional SP 4.0
Intel Xeon 3.40GHz
3 GB RAM
Windows XP SP 2