krywarick6
Automotive
- Jun 9, 2003
- 138
I'm trying to add a length for a bolt into the data standards for Toolbox.
I can disable existing lengths, but I can't seem to find a way to add a new one in.
This is where I am looking:
Tools/Options/ - System Options Tab - Data Options/Edit Data Standards -
ANSI Metric/Bolt & Screws/Hex Head/Hex Flange Screw - Length tab
Any suggestions on how to add a new length?
I'd like to add the information into this area instead of having to manually add the information into the model or have a separate special purpose model.
Christopher Zona - Product Designer
Concord, Ontario
I can disable existing lengths, but I can't seem to find a way to add a new one in.
This is where I am looking:
Tools/Options/ - System Options Tab - Data Options/Edit Data Standards -
ANSI Metric/Bolt & Screws/Hex Head/Hex Flange Screw - Length tab
Any suggestions on how to add a new length?
I'd like to add the information into this area instead of having to manually add the information into the model or have a separate special purpose model.
Christopher Zona - Product Designer
Concord, Ontario