Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolerances for ISO 13920 when not specified in the drawings.

Status
Not open for further replies.
D41

D41

Mechanical
Sep 18, 2018
1
I ask for guidance regarding the tolerances according to ISO 13920. We received drawings for water tanks from the client.
According to the ISO 13920 the tolerance class from A to D should be specify on the drawing but it's not. However for ISO 2768 they added- mK ( medium so no issues there). Can someone tell my if there is a default tolerance in this case?
Thank YOU very much.

 
Replies continue below

Recommended for you

Sort by date Sort by votes
No.
The drawing is incomplete. Call your customer and ask for a revision.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom