Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolerance stack up of Form

Status
Not open for further replies.
rfhall

rfhall

Mechanical
Joined
Jan 9, 2003
Messages
5
Location
US
Ineed to perform a tolerance stackup to include form requirements (profile, parallelism, etc)

What is the best way to perform this. I am planning to do a Monte Carlo analysis. Is Normal distribution correct

Is there a web site with sample that may help.

Thanks
 
Status
Not open for further replies.

Similar threads

L
  • Locked
  • Question Question
Help setting up a tolerance stack up analysis for a door latch assembly
Replies
1
Views
2K
3DDave
3DDave
Wani_1
  • Helpful tip Helpful tip
Design of Built-up section.
Replies
5
Views
8K
GregLocock
GregLocock
Poorpaulus
  • Question Question
Tightest realistic tolerance of a 200mm ID cylinder
Replies
11
Views
4K
GregLocock
GregLocock
moiz19670309
  • Question Question
Hole size with tolerance for Shaft
Replies
7
Views
8K
Gr8blu
Gr8blu
Colclst6
  • Locked
  • Question Question
RSS Tolerance Stack Analysis involving differing number of washers
Replies
3
Views
713
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top