TITLEBLOCK and FORMAT

[defcon888]

Please excuse my NEWBIE question. I am not a NEWBIE to Pro/E. I have over 16,000 hours into it, the problem is, I don't have 16,000 with Wildfire. I have switched jobs over the last few years and every company I have worked for hasn't used Wildfire so I was never exposed to it. The company I work for now uses it on a limited basis. We have Wildfire 1.0.


My question is:


How do you insert a new titleblock into an existing drawing?. I know how to in 2001 and before, but I can't seem to figure it out here.


Once someone tells me I will more than likely slap my forehead with a "doh" and then turn red with embarrassment. Again, I know it is a newbie question which I am not....thanks!

 

[dr_gallup]

In WF2 it is: RMB, Page Setup. Pick Format & scroll down or pick browse.

 

[defcon888]

Thank you Dr.





I think I was channeling your knowledge because as soon as you posted I found something on the forum that explained it.....it is all good now!


Thanks for response.....it is all coming back to me!