Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Titanium Flange ANSI B 16.5

Status
Not open for further replies.
bmoorthy

bmoorthy

Mechanical
Joined
May 29, 2003
Messages
457
Location
CA
B 16.5 does not address Titanium flange.

Suppose one needs 150 Rating 6" Titanium Flange, where can one find the pre published allowable stress at 100 Dec C?
 
Sort by date Sort by votes
As recommended by Annex B of the 2003 Edition, you should check with ASME Section II, Part D.
 
Upvote 0 Downvote
Oh - and the Standard is an ASME standard so the appropriate designation for the Standard is ASME B16.5. (Not ANSI)...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Mauro Nicoli
  • Locked
  • Question Question
ANSI 16.5
Replies
6
Views
1K
Mauro Nicoli
Mauro Nicoli
ShlomoB
  • Locked
  • Question Question
Adding the same balloon multiple times in a drawing (ANSI)
Replies
3
Views
3K
ewh
ewh
Tmoose
  • Locked
  • Question Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
986
Tmoose
Tmoose
Quality Improvement 1
  • Locked
  • Question Question
ANSI Standard requiring changing part number vs revision
Replies
3
Views
1K
looslib
looslib
apolq
  • Locked
  • Question Question
DIN vs ANSI (mating flanges)
Replies
1
Views
960
mk3223
mk3223

Part and Inventory Search

Sponsor

Back
Top