Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tips on moulding a commutator cone.

Status
Not open for further replies.
Tommo1200

Tommo1200

Electrical
Joined
Aug 24, 2012
Messages
1
Location
GB
Could do with a few tips on insulating a commutator cone with moulding mica and shellac.I've repaired a few before,but not moulded one from scratch.This one is just over one foot in diameter........cheers.
 
Status
Not open for further replies.

Similar threads

sidpred
  • Question Question
Commutator marks in DC Motors
Replies
9
Views
14K
samlevy0515
S
jraef
  • Question Question
Excitation current on induction motor as a generator via VFD
Replies
9
Views
4K
LionelHutz
LionelHutz
Toeknee101
  • Locked
  • Question Question
Old English DC excited generator commutator brushes wont stop arcing
Replies
6
Views
593
Gr8blu
Gr8blu
rockman7892
  • Locked
  • Question Question
Sizing a diesel generator based on metering data
2
Replies
22
Views
10K
waross
waross
edison123
  • Locked
  • Question Question
Is an isolation transformer needed on a VFD input side?
2
Replies
24
Views
14K
System Protection
System Protection

Part and Inventory Search

Sponsor

Back
Top