NicklausMorand
Mechanical
Is there a way to tie the fix index number to a note? Like extract[rpt.index,1,3]? I can get the bom to populate by using parameters but I'm curioous if it can work the other way around.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tieing BOM fix index to a note in a drawing sheet.
- Thread starter NicklausMorand
- Start date
- Status
Similar threads
- Question
- Locked
- Question