Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

tie layer that could be used to co-extrude Teflon and HDPE

Status
Not open for further replies.
suzanparvez

suzanparvez

Mechanical
May 26, 2006
28
I need information regarding a tie layer that could be used to co-extrude Teflon and HDPE.
 
Status
Not open for further replies.

Similar threads

muffinator_777
  • Locked
  • Question
Composite stuck to mdf mold
Replies
14
Views
1K
moon161
moon161
Cisnerjo
  • Locked
  • Question
When to use a N4 or N10 air breather 1
Replies
1
Views
813
Compositepro
Compositepro
astro_boy
  • Locked
  • Question
Dissimilar Material between Carbon Steel Flange to Stainless Steel Strainer
Replies
2
Views
628
SWComposites
SWComposites
Oluwakay
  • Locked
  • Question
HOW TO OBTAIN ORTHOTROPIC PARAMETERS FOR A FIBER REINFORCED COMPOSITE
Replies
2
Views
894
Oluwakay
Oluwakay
Cisnerjo
  • Locked
  • Question
Composite Part Stuck to a Mold 2
Replies
10
Views
984
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top Bottom