Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

thread408-205579 ASME PCC-2-2011

Status
Not open for further replies.
MS2017

MS2017

Mechanical
Joined
Jun 1, 2003
Messages
2
Location
CA
thread408-205579

ASME PCC-2-2011
Article 3.5
Flange Repair and Conversion
"Under-thickness of a raised face due to refinishing
shall be acceptable, provided the minimum finished
height of the raised face is 0.8 mm (0.031 in.)".
 
Status
Not open for further replies.

Similar threads

Inchtain
  • Locked
  • Question Question
Pressure Testing of Valves 2
Replies
14
Views
3K
Marc-01
M
skengg
  • Locked
  • Question Question
ASME B16.34 V/S ASME SEC. VIII DIV.1 APPENDIX 2 BOLTED JOINT CACLULATION COMPARISON,
Replies
0
Views
688
skengg
skengg
skengg
  • Locked
  • Question Question
2-PIECE BALL VALVE GLAND FLANGE BOLTING DESIGN QUERY
Replies
8
Views
967
LittleInch
LittleInch
Eng.Husky
  • Locked
  • Question Question
Difference between working pressure and ceiling pressure in asme b16.34
Replies
1
Views
512
PeterIgg
PeterIgg
Eng.Husky
  • Locked
  • Question Question
Monoflange according to asme b16.34
Replies
9
Views
503
Eng.Husky
Eng.Husky

Part and Inventory Search

Sponsor

Back
Top