Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Thread Presence

Status
Not open for further replies.
davej

davej

Industrial
Jun 12, 2001
6
Does anyone have any ideas for a simple method to check for the presence of threads in weldnuts? Automatic? I would prefer to check them on my assembly rather then presort.
 
Status
Not open for further replies.

Similar threads

dog241
  • Locked
  • Question
measuring thread depth for blind hole
Replies
5
Views
862
Rank Li
Rank Li
Mintle
  • Locked
  • Question
Thread Ring Gage Help
Replies
2
Views
424
Tmoose
Tmoose
65CCJ
  • Locked
  • Question
Thread Form isn't correct but gages OK for 1"NPT Male Thread - Is the picture grounds for scrap 1
Replies
8
Views
459
65CCJ
65CCJ
CG1017
  • Locked
  • Question
Inspection of Depth of Threaded Holes
Replies
3
Views
890
3DDave
3DDave
DuncanGibbons
  • Locked
  • Question
Axial fatigue specimen fractured at threaded ends
Replies
0
Views
208
DuncanGibbons
DuncanGibbons

Part and Inventory Search

Sponsor

Back
Top Bottom