Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

The Tolerator & Filetor

Status
Not open for further replies.
fighterpilot

fighterpilot

Military
Joined
Nov 5, 2004
Messages
381
Location
US
I've had these for a few years now and they are quite handy. I could not find them in the states and ended up getting them on a trip to Switerland one year. I don't know if one exists for tolerancing inch size holes but if it does, I'd like to get one.


Any ideas?

thanks...

--
Fighter Pilot
Manufacturing Engineer
 
Status
Not open for further replies.

Similar threads

A
  • Question Question
Shaft can't fit in the hole.
2
Replies
27
Views
4K
juergenwt
juergenwt
ericscottf
  • Locked
  • Question Question
Proper GD&T for interrupted threads?
Replies
14
Views
1K
ericscottf
ericscottf
G
nX / nSURFACES notation can be used for all the GD&T character?
2
Replies
20
Views
12K
pmarc
pmarc
rollingcloud
  • Locked
  • Question Question
Is my understand of the FRTZF correct?
Replies
7
Views
5K
rollingcloud
rollingcloud
Algirdas13
  • Locked
  • Question Question
Starting on GD&T & Tolerances
Replies
12
Views
700
geesaman.d
geesaman.d

Part and Inventory Search

Sponsor

Back
Top