Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
The Suitable Q275 Grade for tank design
- Thread starter Omer Mohd
- Start date
Dhurjati Sen
Materials
Dear Omer Mohd,
If you are using Chinese grade steel, then why not go for the cheapest grade?
Regards.
DHURJATI SEN
Kolkata, India
If you are using Chinese grade steel, then why not go for the cheapest grade?
Regards.
DHURJATI SEN
Kolkata, India
- Thread starter
- #3
Dear Dhurjati Sen,
Thanks for your reply, of course cost is the one of the most important factors in the design process. But that what was my question about.
after all, i think I'm going with grade C. it has the highest quality among the killed grades
Thanks for your reply, of course cost is the one of the most important factors in the design process. But that what was my question about.
after all, i think I'm going with grade C. it has the highest quality among the killed grades
Dhurjati Sen
Materials
Dear Omer Mohd,
That's ok. Do ensure that lamination is not present. Specify UT in the P.O. itself.
Regards.
DHURJATI SEN
Kolkata, India
That's ok. Do ensure that lamination is not present. Specify UT in the P.O. itself.
Regards.
DHURJATI SEN
Kolkata, India
- Status