I have developed a flyable and controllable model of a flying rotor. I am exploring the possibilities of the airfoil for one of these models (presently built out of wood 1.5" X 24" X .250) being produced in a hollowed out configuration that would be extremely light and yet quite strong. Can anyone shed information on this subject? Composite would be great but even a simple plastic might work?????
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
THE MASS PRODUCING OF A MODEL ROTORBLADE
- Thread starter jplot
- Start date
- Status