I am using ANSYS full in Harmonic response analysis. My model is made up of one part which is made up of more than one body. (A composite fiber of 3 layers).
Whenever I add frequency response at a point between layers, it would not work. I get an error message that the point is on different bodies!
I tried placing the point only on one body but I still get the same message.
I am interested in the radial stress on the interface between the layers at different frequencies.
Whenever I add frequency response at a point between layers, it would not work. I get an error message that the point is on different bodies!
I tried placing the point only on one body but I still get the same message.
I am interested in the radial stress on the interface between the layers at different frequencies.