Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tapped hole Callout
- Thread starter Finglas
- Start date
- Thread starter
- #2
JohnRBaker
Mechanical
Delete the old Dimensions and then go to...
Tools -> Drafting Standard...
...and change the Standard to 'ASME(Shipped)'.
Now go back to your drawing and select...
Insert -> Dimension -> Feature Parameters...
...and expand the navigator tree until you see the threaded hole features (there should be a pair of them with the same name but different icons). Select them both, press MB2 and then select the Drawing view where you wish to see the Callout placed and then hit OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
Tools -> Drafting Standard...
...and change the Standard to 'ASME(Shipped)'.
Now go back to your drawing and select...
Insert -> Dimension -> Feature Parameters...
...and expand the navigator tree until you see the threaded hole features (there should be a pair of them with the same name but different icons). Select them both, press MB2 and then select the Drawing view where you wish to see the Callout placed and then hit OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Status