Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tabs

Status
Not open for further replies.
RAMviking

RAMviking

Mechanical
Joined
Oct 29, 2006
Messages
40
Location
NO
When I start a new document with the aid of New dialog box there are some tabs I don’t understand.
1. Reports tab; is empty, how do I make a template?
2. Tutorial tab: When shall I use these templates?

Best regards
Ramviking
SE V19 SP7
 
Sort by date Sort by votes
Those tabs happen to be there because automatically SE will create a tab for each folder inside the targeted folder for your templates. If you target your own folder for your templates SE will create tabs of it and will keep his original tabs at the end.

So there is a tab "reports" that contains the format of your reports, this tab has nothing to do with creating a new part.

For The tab "tutorial" I think it's there because they had no better place where to put it.

Patrick
 
Upvote 0 Downvote
Thanks!
Ramviking
SE V19 SP7


Solid Edge V19
SP 7
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top