Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Table Curve

Status
Not open for further replies.

ianstifle

Marine/Ocean
Joined
Jun 30, 2004
Messages
14
Location
US
I've created a group of 38 table curves in an attempt to easily create a lofted protrusion of a ship's hull. the curves are all parallel to each other. However, when I go to the lofted protrusion command it will not accept the input from a table curve. any suggestions on how to do this without tracing each curve into a sketch??
 

You may want to use the 'Curve by Table' command to create the curves. You can use these curves as cross sections for BlueSurf or Lofted Surface commands. After creating the surface, use 'Thicken' command to create a solid.

HTH.

Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top