I just acquired a Systron Donner HR40-10C power supply.
It seems to be working fine and I seem to have figured out how to set it up to limit both voltage and amperage.
I have searched on line and there is no manual or information about the operation of these units to be found as they are quite old.
Does anyone have an information or a source?
Thanks!
It seems to be working fine and I seem to have figured out how to set it up to limit both voltage and amperage.
I have searched on line and there is no manual or information about the operation of these units to be found as they are quite old.
Does anyone have an information or a source?
Thanks!
