Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface skews when using "AM2SF" command

Status
Not open for further replies.
eng426

eng426

Mechanical
Joined
Jun 27, 2003
Messages
25
Location
US
I generate a 3dmesh in autocad from a script file using "3DMESH M x N". Then I convert it to a surface using "AM2SF". When I view it wireframe, it looks very close to my mesh, but when I view it in "shaded" it seems off and distorted in some areas. Therefore converting it to a surface causes some distortion or discontinuities. Anyone else seen this and/or could explain how to hold it closer to its' shape? Any help appreciated.
Thanks,
Eng426
 
Status
Not open for further replies.

Similar threads

Brian3163
  • Locked
  • Question Question
Joining surfaces
Replies
0
Views
2K
Brian3163
Brian3163
grippy
  • Locked
  • Question Question
AutoCAD2005 "Fatal Error" help.
Replies
0
Views
238
grippy
grippy
Martynw
  • Locked
  • Question Question
Unable to log in on XP using MD5
Replies
0
Views
205
Martynw
Martynw
Saintaholic
  • Locked
  • Question Question
How Do I Find Out Whos Using Licenses?
Replies
0
Views
195
Saintaholic
Saintaholic
Jamaz17
  • Locked
  • Question Question
How do I show the command line ?
Replies
0
Views
146
Jamaz17
Jamaz17

Part and Inventory Search

Sponsor

Back
Top