surface extend problem

[bartbrejcha]

Ill bet it's me but I get differing results when trying to make a surface extend in UG. Sometimes the surface extend gets dislocated and becomes disconnected. I would imagine there to be several settings there too.

1 strait extend with respect to an angle. G0
2 a G1 or tangental extend (where users can see tangent line)
3 a G2 or curvature extend (same surface no tangent line)

The other side worked fine

What can I do to extend a surface that has been swept along two or more tangent curves?

Bart brejcha training consultant

http://www.designengine.com

 

[JohnRBaker]

Can you upload the actual model file?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Xwheelguy]

What is the result if you use Enlarge versus Extend? How about Isoparametric Trim/Divide (if not retired in the version you're using)?

Tim Flater
NX Designer
NX 8.0.3.4
Win7 Pro x64 SP1
Intel Xeon 2.53 GHz 6GB RAM
NVIDIA Quadro 4000 2GB

 

[bartbrejcha]

how do I get to enlarge? I see extend surface but not enlarge surface?

Bart brejcha training consultant

http://www.designengine.com

 

[cowski]

Edit -> surface -> enlarge

When in doubt, use the command finder!

www.nxjournaling.com