Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Supposrted Cone Roof Design

Status
Not open for further replies.

carletes

Chemical
Jan 28, 2003
79
Dear all!

I am quite new in API 650 design, and I have a question about supported cone roof design. Is there any API publicatiosn regarding this issue? (rafters design, compression ring, shell to roof junction, etc) because I think it is not included in API 650. Or perhaps there is any other publication about this topic that is usually used in the industry and generally accepted?

Thanks a lot and best regards,

 
Replies continue below

Recommended for you

There is also a suggested procedure and an example for the design of a supported cone roof (for API-650 tanks) in "Design of Pressure Vessels" by Brownell & Young.

Richard Ay
COADE, Inc.
 
A caution... The Brownell and Young method likely does not comply with current API requirements. I think that book is quite old. API-650 has had some significant changes to some of the design requirements.

Steve Braune
Tank Industry Consultants
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor