Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Subroutine URDFIL - set LSTOP=0

Status
Not open for further replies.
alfrd

alfrd

Structural
Joined
Aug 13, 2009
Messages
1
Location
IR
Hello

I have problem with a model in Abaqus which is consist of two steps. I use URDFIL subroutine to stop the analysis in the first step in special condition by LSTOP=1. Then, it will not start the second step.
I think it's because of that LSTOP will not set 0 at the end of first step. How can I set LSTOP=0 for second step?
Is any other way possible for this situation?

Thanks
 
Status
Not open for further replies.

Similar threads

I
  • Locked
  • Question Question
Abaqus subroutine
Replies
3
Views
3K
FEA way
FEA way
I
Abaqus Subroutine
Replies
4
Views
6K
FEA way
FEA way
M
  • Locked
  • Question Question
Assistance with VUHARD Subroutine in Abaqus
Replies
3
Views
3K
FEA way
FEA way
J
  • Question Question
Error Running eigensolver (ABAQUS/standard rank 0 encountered a SEGMENTATION FAULT)
Replies
1
Views
2K
FEA way
FEA way
F
  • Question Question
ABAQUS error - 'Node set assembly_left_rp' has not been defined
Replies
1
Views
3K
Vishakh_Rajendran
Vishakh_Rajendran

Part and Inventory Search

Sponsor

Back
Top