Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Subplate standards

Status
Not open for further replies.
BakerT

BakerT

Mechanical
Joined
Jun 8, 2006
Messages
1
Location
US
Valve subplates are typically built to an industry standard which covers pressures up to 10000 psi as a maximum. I was wondering if anyone knows of a standard that has been or is in the works for pressures in the range of 15000 psi.
 
Status
Not open for further replies.

Similar threads

YETI123
  • Locked
  • Question Question
European Valve Standards ax opposed to Asme Standards
Replies
11
Views
808
TheValveLady
TheValveLady
Fuzzbox 100
  • Locked
  • Question Question
British Standards for Check / Non-Return Valves
Replies
4
Views
600
Fuzzbox 100
Fuzzbox 100
Shabaaz
  • Locked
  • Question Question
Any additional Valve standards for valves used in HIPPS
Replies
1
Views
218
The Obturator
The Obturator
springwaterbr
  • Locked
  • Question Question
Standards and practices on largest diameter for valves without a gear operator
Replies
12
Views
1K
Nick_Gray_88
Nick_Gray_88
Rubio123
  • Locked
  • Question Question
Adecuacy of Butterfly valves to American standards - API 609
Replies
2
Views
165
gerhardl
gerhardl

Part and Inventory Search

Sponsor

Back
Top