thread561-275104
Hi - I have a comment to this thread.
I have excatly the same problem as in this thread.
Does someone know if there have been done some software change the last 3 -4 years about the possibillity,
to set a attribute in a subassembly, containing the entire subassembly weight ?
I have a situation now at my new Company, where we are in migration to NX (500+) users .
And we need to have partslist with subassemblies - and the calculated weight as a attribute in the subassembly part.
In the assemblynavigator the subassemblies IS calculated - where comes this value from.?
Can it be "asked" during a NX open program?
lklo
Hi - I have a comment to this thread.
I have excatly the same problem as in this thread.
Does someone know if there have been done some software change the last 3 -4 years about the possibillity,
to set a attribute in a subassembly, containing the entire subassembly weight ?
I have a situation now at my new Company, where we are in migration to NX (500+) users .
And we need to have partslist with subassemblies - and the calculated weight as a attribute in the subassembly part.
In the assemblynavigator the subassemblies IS calculated - where comes this value from.?
Can it be "asked" during a NX open program?
lklo
