Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Stress wizzard?

Status
Not open for further replies.
Lars1978

Lars1978

Mechanical
Dec 30, 2015
327
Hi All,

When I have done a stress wizzard it run OK. But where can I alter the values in the wizzard and run it again?

Kind regards

Lars
 
Replies continue below

Recommended for you

Sort by date Sort by votes
You can save the simulation and reopen if you have a Design Simulation or Advanced Simulation license.
Otherwise, you have to rerun the wizard.

Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (29versions)
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Ritchie
  • Locked
  • Question
NX stress wizzard force applied to point
Replies
1
Views
290
Toost
Toost
Ritchie
  • Locked
  • Question
Stress Wizard simulation report young's modulus input
Replies
0
Views
118
Ritchie
Ritchie
Lars1978
  • Locked
  • Question
stress wizard material definitions
Replies
0
Views
73
Lars1978
Lars1978
Lars1978
  • Locked
  • Question
stress wizard issues
Replies
3
Views
216
SDETERS
SDETERS
thakurai
  • Locked
  • Question
Torsion in shafts: shear stress calculation error
Replies
0
Views
158
thakurai
thakurai

Part and Inventory Search

Sponsor

Back
Top Bottom