Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

STRESS RELIEVING REQUIREMENTS OF KNUCKLE PORTION AS PER API 620

Status
Not open for further replies.
Anish Ramachandran

Anish Ramachandran

Mechanical
Joined
Jan 22, 2020
Messages
1
Location
NG
Sirs,
Please clarify whether stress relieving is required for knuckle to knuckle plate joints & the nozzles on knuckle plates of A516 Gr. 70 with thickness of 46mm.
Thanks & regards,
Anish
 
Sort by date Sort by votes
Dear Anish Ramachandran,

Check Section 5.25.3 Wall Thickness

Regards.

DHURJATI SEN
Kolkata, India

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
  • Locked
API 620 does discuss abt RF pad for lug support
Replies
1
Views
1K
crshears
crshears
mechengineer
  • Question Question
Studding Flange Design as per Code
Replies
1
Views
3K
r6155
r6155
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee
aiwa7777
  • Locked
  • Question Question
Membrane Stress
Replies
2
Views
2K
aiwa7777
aiwa7777
jayinwww
  • Question Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
445
jayinwww
jayinwww

Part and Inventory Search

Sponsor

Back
Top