Strength Wizard missing under Analysis in NX8.5

[NXsupport]

Hi ,

I was wondering where is Strength Wizard in NX8.5.. It was a great tool for quick analysis in NX6.0

Thanks for guiding me..

Brest Regards

 

[Toost]

If I remember things correct, Strength Wizard is retired and for those who had the license replaced by "Design Simulation".
You lack the wizard user interface but you gain flexibility and capability.

I think it retired/replaced in NX6 or 7.5.


Regards,
Tomas

 

[JohnRBaker]

It's still there. It's simply been renamed to the 'NX CAE Stress Wizard' and is now accessed from the 'Process Studio' tab on the Resource Bar, along with a couple of additiona CAE 'Wizards', as shown below and in the attached file:

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[NXsupport]

Hi John,

Thanks for the information.. This is very helpful..