T
TNDave
Guest
Solidworks 2020:
I have a part (file attached) that I am trying to put a circular pattern of a rib, but it works at any angle up to 203 degrees, fails at 204. I need it to be at 212 degrees. It is the last feature in the tree. Can someone tell me why this fails at 204 degrees and will not go to 212?
I have a part (file attached) that I am trying to put a circular pattern of a rib, but it works at any angle up to 203 degrees, fails at 204. I need it to be at 212 degrees. It is the last feature in the tree. Can someone tell me why this fails at 204 degrees and will not go to 212?
