gfbotha
Mechanical
- Apr 13, 2006
- 130
Hi SEdgers
We have to supply a STEP translation to another company (using Pro-E) - the assembly contains a lot of parts with different densities. In our type of business mass is quite important but we cannot get the STEP file to carry over the density values. I have been under the impression that by now this has been incorporated into the STEP standard?! And, thought I once got this right...
We tried various STEP exporting options (including AP214 protocol) but the densities are being dropped - even when reading back the file ourselves. As we only install every 2nd release, we are still using SEdge v18.
Thanks for any comments/tips.
Regards
Gert
We have to supply a STEP translation to another company (using Pro-E) - the assembly contains a lot of parts with different densities. In our type of business mass is quite important but we cannot get the STEP file to carry over the density values. I have been under the impression that by now this has been incorporated into the STEP standard?! And, thought I once got this right...
We tried various STEP exporting options (including AP214 protocol) but the densities are being dropped - even when reading back the file ourselves. As we only install every 2nd release, we are still using SEdge v18.
Thanks for any comments/tips.
Regards
Gert