Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Steel Shop Drawing: BTS?

Status
Not open for further replies.

dcredskins

Structural
Feb 4, 2008
62
I found an abbreviation BTS in steel shop drawing, what does it mean? I know FS (far side) and NS (near side). I would appreciate your help.
 
Replies continue below

Recommended for you

Both Sides?

Bottom of Tube Steel?

 
Thanks UcfSE. This makes sense. Also, thanks for PDF.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor