ulloap
Mechanical
- Jul 5, 2007
- 22
Hi guys,
Im stucked trying to model a very simple FEA, I need to heat up a pvc pipe applying air convection load, to find time needed to.
I did and steady state axisymetric model, and apply a Surface Film and initial temperature by a predefined condition, but looks like the temperature never reach the goal, even if I increase time, or film convection coefficient.
Can somebody guide me on it, also how can I find the time to reach a temperature in abaqus?
Then I need to create a new transient step to cooling down it, again I need to find the time needed to reach that condition, by a forced convection water.
I appeciate the guidance you can give me.
Regards
Im stucked trying to model a very simple FEA, I need to heat up a pvc pipe applying air convection load, to find time needed to.
I did and steady state axisymetric model, and apply a Surface Film and initial temperature by a predefined condition, but looks like the temperature never reach the goal, even if I increase time, or film convection coefficient.
Can somebody guide me on it, also how can I find the time to reach a temperature in abaqus?
Then I need to create a new transient step to cooling down it, again I need to find the time needed to reach that condition, by a forced convection water.
I appeciate the guidance you can give me.
Regards